(Original) Download Nokia 6 TA-1021 Stock Firmware [Flash File]
(Original) Download Nokia 6 TA-1021 Stock Firmware [Flash File]

(Original) Download Nokia 6 TA-1021 Stock Firmware [Flash File]

(Original) Download Nokia 6 TA-1021 Stock Firmware [Flash File]

To fix issues with bootloop, system faults, unbrick dead after flash, screen lock, pattern lock, FRP / Google Account, hanging, and dead issues, use the Nokia 6 TA-1021 Stock Rom (Flash File). Use OST or QFIL to flash stock firmware.

Nokia 6 TA-1021 Firmware Update (Android 8.0)

Firmware Information
File NameNokia6_Android_8.0_February2018_Update .zip
RegionGlobal
File TypeUpdate File
Device SupportsNokia 6
File Size1.7 GB
Flash MethodUsing OST Tool
Download
Firmware Information
File NameNokia_6_TA-1021_MSM8937_28122017_7.1.1_QFIL.zip
RegionGlobal
File TypeSplit File
Device SupportsNokia 6
File Size1.9 GB
Flash MethodUsing QFIL
Download

Download Flashtool + USB Driver Nokia 6

How To Flash Stock ROM On Nokia 6 TA-1021 Using OST

  • Open the folder where the Nokia Online Service tool is installed.
  • Look for a file named “OnlineUpdateTool.exe” and double click on the same to run it.
  • Once you open the Nokia Online Service tool.
  • Click the Next button.
  • Here you will need to choose the file location which you need to flash your Nokia device.
  • Reboot the device into Download Mode by following the below steps;
    1. Switch off your device.
    2. Connect the USB cable to your phone (leave the other end open for now).
    3. Press and hold Volume Down + Power buttons together.
    4. Wait till your phone vibrates and you see a “POWERED BY Android” in the screen along with “Download  Mode” at the top or bottom corner.
  • Select the firmware, and click the “Edit Phone Information” button on the bottom right corner will become enabled.
  • An error message will show up. Simply click OK.
  • The firmware flashing process would have begun by now. Besides, it might take a few minutes to finish. Moreover, this is standard behavior and nothing to worry about.

How To Flash Stock ROM On Nokia 6 TA-1021 Using QFIL

  1. Download and install Qualcomm USB Driver on your Computer (If you have already installed the Qualcomm USB Driver on your computer, skip this step)
  2. Download and extract Qualcomm Flash Image Loader (QFIL) on your computer. After extracting, you will be able to see the following files:
  3. Now, Run the QFIL tool
  4. QFIL is launched
  5. Connect the device to the computer while in EDL Mode (device should be in EDL before connecting to pc). No Port Available should change to Qualcomm HS-USB QDLoader 9008
  6. Under Select Build Type, tick Flat Build
  7. Under Select Programmer, click Browse. In the Window that pops up, highlight the loader file (usually named prog_emmc_firehose_****.mbn) and click Open
  8. Click Load XML
  9. In the Window that pops up, highlight the rawprogram() file then click Open
  10. Another Window will automatically pop up, highlight the patch() file then click Open
  11. Click Download, QFIL should start flashing the firmware, Do Not interrupt
  12. You should get Download Succeed Finish Download once QFIL has successfully flashed the firmware. 
  13. Disconnect the device and boot up

Comments

No comments yet. Why don’t you start the discussion?

Leave a Reply

Your email address will not be published. Required fields are marked *